Product

If you would like to replace your existing gMax 1.5+ Dual J-Head hotends with new E3D V6 hotends, this set is for you. It comes with everything you need to swap the hotends on your existing gMax 1.5+ motor bracket.

When switching from J-Head to E3D Hotends, you MUST install the new firmware with the correct configuration file. Refer to our forum page for installation instructions.

Link to updated firmware: https://www.youtube.com/watch?v=oNzjBsg3XoM

Link to Install Guide: http://forum.gcreate.com/index.php?threads/dual-e3d-upgrade-kit.925/

E3D hotends are longer than standard J-Head hotends and require a longer bltouch bracket and fan shroud. This set includes the bracket and shroud.

Product Contains:

• 2x Fully Assembled E3D v6 All-Metal Hotends with cooling fans and wires.
• 2x PTFE tubes for E3d (to replace shorter J-Head PTFE tube)
• 3D Printed Fan Shroud for Dual E3D w/ (2) 4-40 Nuts and (2) 1/2" Screws)
• (5) Zip Ties
• BLTouch Leveling Sensor 3d Printed Bracket w/ 2 Locknuts (Bracket Only)
• Active Cooling Fan Wire Y-Splitter w/ Header Pins

Note: Hotends come FULLY ASSEMBLED

Made in the USA